U-Boot 2012.07-00050-g462cda0 (Jan 20 2014 - 15:20:21) for XYREF5260
CPU: Exynos5260 Rev1.0 [Samsung SOC on SMP Platform Base on ARM CortexA7]
Board: XYREF5260
DRAM: 2 GiB
WARNING: Caches not enabled
TrustZone Enabled BSP
BL1 version: 20140109
Chip ID : 03364d879413
PMIC: S2MPA01(REV1)
MIF: 1000mV EGL: 1000mV INT: 1000mV G3D: 1000mV KFC: 1000mV
RTC_BUF: 0x13, WRSTBI: 0xfc
BUCK9: 0xd4
S2MPA01_INT1: 0x0
S2MPA01_INT2: 0x10
S2MPA01_INT3: 0x0
S2MPA01_STATUS1: 0x16
S2MPA01_STATUS2: 0x0
PWRONSRC: 0x1
OFFSRC: 0x0
S2MPA01_RTC: 0xe3
WTSR not detected
SMPL not detected
Checking Boot Mode ... EMMC
MMC: S5P_MSHC0: 0, S5P_MSHC2: 1
MMC Device 0: 3.6 GiB
MMC Device 1: 7.4 GiB
MMC Device 2: MMC Device 2 not found
In: serial
Out: serial
Err: serial
rst_stat : 0x10000000
[Partition table on MoviNAND]
ptn 0 name='fwbl1' start=0x2 len=N/A (use hard-coded info. (cmd: movi))
ptn 1 name='bl2' start=N/A len=N/A (use hard-coded info. (cmd: movi))
ptn 2 name='bootloader' start=N/A len=N/A (use hard-coded info. (cmd: movi))
ptn 3 name='tzsw' start=N/A len=N/A (use hard-coded info. (cmd: movi))
ptn 4 name='kernel' start=N/A len=N/A (use hard-coded info. (cmd: movi))
ptn 5 name='ramdisk' start=N/A len=0x0(~27262976KB) (use hard-coded info. (cmd: movi))
ptn 6 name='system' start=0x2 len=0x0(~736969728KB)
ptn 7 name='userdata' start=0x2 len=0x0(~1260103680KB)
ptn 8 name='cache' start=0x2 len=0x0(~736969728KB)
ptn 9 name='fat' start=0x2 len=0x0(~958442496KB)
----
power on button click
U-Boot 2012.07-00050-g462cda0 (Jan 20 2014 - 15:20:21) for XYREF5260
CPU: Exynos5260 Rev1.0 [Samsung SOC on SMP Platform Base on ARM CortexA7]
Board: XYREF5260
DRAM: 2 GiB
WARNING: Caches not enabled
TrustZone Enabled BSP
BL1 version: 20140109
Chip ID : 03364d879413
PMIC: S2MPA01(REV1)
MIF: 1000mV EGL: 1000mV INT: 1000mV G3D: 1000mV KFC: 1000mV
RTC_BUF: 0x13, WRSTBI: 0xfc
BUCK9: 0xd4
S2MPA01_INT1: 0x43
S2MPA01_INT2: 0x11
S2MPA01_INT3: 0x0
S2MPA01_STATUS1: 0x16
S2MPA01_STATUS2: 0x0
PWRONSRC: 0x1
OFFSRC: 0xc0
S2MPA01_RTC: 0x23
WTSR not detected
SMPL not detected
Checking Boot Mode ... EMMC
MMC: S5P_MSHC0: 0, S5P_MSHC2: 1
MMC Device 0: 3.6 GiB
MMC Device 1: [ERROR] response timeout error : 00000104 cmd 1
Card did not respond to voltage select!
In: serial
Out: serial
Err: serial
rst_stat : 0x10000
Net: smc911x: Invalid chip endian 0x00000000
No ethernet found.
Hit any key to stop autoboot: 0
reading kernel..device 0 Start 1263, Count 16384
MMC read: dev # 0, block # 1263, count 16384 ... 16384 blocks read: OK
completed
reading RFS..device 0 Start 17647, Count 2048
MMC read: dev # 0, block # 17647, count 2048 ... 2048 blocks read: OK
completed
Starting kernel ...
Uncompressing Linux... done, booting the kernel.
...
[ 15.702770] [5] acc_open
[ 15.703840] [5] acc_release
[ 16.340697] [0] mtp_open
[ 17.590507] [1] init: sys_prop: permission denied uid:1003 name:service.bootanim.exit
--------------'
회원정보
미니박스
메일
쪽지
문자
채팅
포스트
댓글
친구맺기
친구제외
방명록
선물하기
파일박스
홈페이지